Contents
- Brass toilet bolts.
- Caulk.
- Flexible water supply.
- Plastic shims.
- Toilet flange.
- Wax ring.
Hook up the supply line between the shut-off valve and the toilet. Use Teflon tape on metal threads (usually the joint where the valve connects to the supply line. Turn the valve on, allow the toilet to fill, and assess for leaks. You should also flush the toilet several times to check for leaks around the base.
Replacing a toilet is a major project, but it is not as difficult as might be imagined. The hardest tasks usually are selecting a new toilet and removing the old one. … Then remove the tank cover, flush the toilet and sponge the tank dry. Use a plumber`s plunger to force as much water as possible out of the bowl.
Turn on the main supply line, open the stop valve, and allow the tank to fill. Flush six times. The final step to installing a toilet is to check for leaks.
Replacing a toilet is a simple and straightforward job, so you should be able to remove the old toilet and install the new one in about two to three hours. However, if you don’t have a lot of DIY experience, you might want to add an hour or two to that timeframe.
National Average: $372 According to HomeAdvisor, toilet installation costs range from $224 to $531, with the national average at $372. The overall cost depends on the type of toilet and the complexity of the job. It takes approximately 2 to 4 hours for a plumber to install a toilet at a base rate of $65 per hour.
A plumber charges around $375 to replace a toilet. Most charge between $275 and $480. This includes the cost of removing and disposing of your old toilet. Note that the actual cost to replace a toilet depends on your location, the type of toilet and the difficulty of the installation.
All you need are a few hours, a helper and the right tools and toilet parts for the job. Before you begin learning how to install a toilet, choose your new toilet, and if you aren’t replacing an existing toilet, make sure you have plumbing ready for the new installation.
The bathroom fitters are unanimous—if you’re looking for a high quality finish, with a better seal against water damage, then always tile the floor first. … The floor will be sealed a lot better with the tiles being laid under the toilet.
Most toilets will have a 12 inch rough-in. … If you’re replacing an existing toilet, look for a replacement toilet with the same rough-in. A toilet with a larger rough-in measurement will require you to change your plumbing configuration or move the wall to get the toilet to fit.
Most codes require at least 15 inches (measured from the center of the toilet) from any side wall or obstruction and not closer than 30 inches center to center to any other sanitary fixture. (The NKBA actually recommends 32 inches.) There should be at least 24 inches of clear space in front of a toilet or bidet.
Toilets usually include a wax ring. However, it’s best to purchase a backup wax ring in case of damage during installation. You can also use a wax-free ring.
Largely maintenance-free (the macerator and pump are usually permanently sealed in an oil-filled enclosure), macerating toilets shouldn’t present any significant problems when installed correctly… provided they’re used correctly.
Do you know how old your toilet is? Although some plumbers would say a toilet could last up to 50 years, a federal law actually states that any toilets built before 1994 that holds more than 1.6 gallons per flush must get replaced.